AMSOIL Bypass Filter and KitsAMSOIL Bypass Filter Kits come in a single by pass BMK21, Dual Bypass BMK23, Dual Bypass Cummins BMK25, Dual Bypass Powerstroke BMK26 and Dual Bypass Duramax BMK27.
 This is a AMSOIL BMK-21 By-Pass Filter Unit bracket shown on a 6.0L Powerstroke. I have it available and in stock. They are professionally made as you can see. Just let me know if you would like this bracket and I'll take care of you. AMSOIL does not supply this bracket.
Call Me. 1-866-870-5048 for prices on any AMSOIL Bypass Unit You will only pay Dealer Cost... The AMSOIL Bypass Oil Filters (EaBP) provide the best possible filtration protection against wear and oil degradation. Working in conjunction with the engines full-flow oil filter, the AMSOIL By Pass Oil Filter operates by filtering oil on a partial-flow basis. It draws approximately 10 percent of the oil pumps capacity at any one time and traps the extremely small, wear-causing contaminants that full-flow filters cant remove. AMSOIL Bypass Oil Filter typically filters all the oil in the system several times an hour, so the engine continuously receives analytically clean oil. If you want to use the BMK-23 dual bypass filter unit on your vehicle, you must have the adapter that goes where the full flow filter is. Choose the adapter below. Adapters to choose with the BMK-23 Dual Bypass Filter Unit If your vehicle uses this AMSOIL filter
| This is the thread used. | This is the adapter kit you should use. | | EaO-10 | 3/4" - 16 | BK-295 | | EaO-13 | 20mm x 1.5mm | BK-298 | | EaO-15 | 3/4" - 16 | BK-295 | | EaO-20 | 20mm x 1.5mm | BK-298 | | EaO-22 | 13/16" - 16 | BK-296 | | EaO-23 | 18mm x 1.5mm | BK-297 | | EaO-24 | 13/16" - 16 | BK-296 | | EaO-25 | 13/16" - 16 | BK-296 | | EaO-26 | 3/4" - 16 | BK-295 | | EaO-29 | 18mm x 1.5mm | BK-297 | | EaO-30 | 13/16" - 16 | BK-296 | | EaO-34 | 3/4" - 16 | BK-295 | | EaO-36 | 20mm x 1.5mm | BK-298 | | EaO-42 | 3/4" - 16 | BK-295 | | EaO-44 | 20mm x 1.5mm | BK-298 | | EaO-47 | 22mm x 1.5mm | BK-299 | | EaO-50 | 22mm x 1.5mm | BK-299 | | EaO-52 | 13/16" - 16 | BK-302 (Special Duramax Unit) | | EaO-57 | 3/4" - 16 | BK-295 | | EaO-64 | 13/16" - 16 | BK-296 | | EaO-80 | 1" - 16 | BK-300 (Cummins unit) | | EaO-96 | 3/4" - 16 | BK-295 | | EaO-99 | 1&1/2" - 16 | BK-301 (7.3 Powerstroke only) |
|
|
|
|
|
| | By-Pass Filter Mounts |  | | | | BMK18 Purchase | BMK21 Purchase | | | When ordering the BMK18, request one of the following adapter kits:
BK195 for 34" x 16 thread
BK196 for 1316" x 16 thread
BK197 for 18 mm x 1.5 mm thread
BK198 for 20 mm x 1.5 mm thread | | | | | BMK25
BMK26
BMK27 Purchase | BMK30 Purchase | | |
 |  | | Sample Kit | Size Measurement |
New Aluminum Billet Oil Fill and Oil Filter Caps for BMK21 By-Pass Filtration System  AMSOIL offers by-pass components (sold separately) to ease the installation of the BMK21 By-Pass Filtration System in three popular diesel engines: the Ford 6.0L Power Stroke, the Dodge 5.9L Cummins and the General Motors 6.6L Duramax.
Engine compartments are becoming increasingly cramped, leaving little room for after-market additions and improvements. The BMK21 is a single remote by-pass filter system that fits into much smaller spaces than the AMSOIL Dual-Remote By-Pass System. Ford 6.0L/6.4L Power Stroke Diesels
To ease installation of the BMK21 on 2003 and later model Ford pickups equipped with the 6.0L and 6.4L Power Stroke diesel engines, AMSOIL offers the new Aluminum Billet Oil Filter Cap (BK1101), the Aluminum Billet Oil Fill Cap (BK1102) and the 90-degree JIC Elbow (BP242, two recommended) (all sold separately). These new high-quality billet aluminum caps replace the original equipment manufacturer (OEM) filter cap and oil fill cap. The new caps have holes tapped in them that accept the JIC elbows for hose connectors. Dodge 5.9L/6.7L Cummins Diesels
To ease installation of the BMK21 in later model Dodge pickups equipped with the 5.9L and 6.7L Cummins diesel engine, AMSOIL offers the 1/8" NPT - 1/4" JIC fitting (BP241), the Aluminum Billet Oil Fill Cap for Dodge 5.9L Cummins diesels (BK1301), for 6.7L Cummins engines use (BK1302), and the 90-degree JIC Elbow (BP242) (all sold separately). The BP241 fits onto the existing plug on top of the OEM full-flow filter mount, and the addition of the BK1301 eases the installation of the oil return line. General Motors 6.6L Duramax Diesels
To provide GM Duramax owners the same ease of installing the BMK21, AMSOIL is now offering an oil filter Sandwich adapter (BK1201). The Sandwich adapter is an anodized billet aluminum adapter that screws on to the present full flow oil filter nipple located on the engine block. The full flow filter is then simply spun on to the adapter. The Sandwich adapter has an orifice to provide high-pressure oil feed for the BMK21. Like the other diesel applications, AMSOIL now offers an Aluminum Billet Oil Filler Cap for (BK1202) to ease the installation of the oil flow from the BMK11 back to the engine. To complete an installation, the following components must be purchased separately: 1. Aluminum oil filter Sandwich Adapter with o-ring (BK1201)
2. Aluminum Billet Oil Filler Cap for GM Duramax (BK1202)
3. Two 90 degree JIC Elbows (BP242)
4. Single Remote By-pass system (BMK21)
5. By-pass filter (EaBP90, EaBP100, or EaBP110, as space dictates) (all sold separately)
|
Higher Efficiency
AMSOIL EaBP Filters have an efficiency of 98.7 percent at two microns. At normal operating RPMs the EaBP Filter will filter all of the oil in a typical five quart sump in less than 10 minutes. Superior Construction
The superior construction of AMSOIL EaBP Filters provides better sealing and increased longevity along with superior corrosion resistance. AMSOIL EaBP Filters have a marine powder coated exterior; and their zinc-dichromate base plates increase rust protection. EaBP Filters have a nitrile HNBR gasket and an orange silicone anti-drain valve. The two stage pleated and layered cellulose/full synthetic media has an efficiency rating of 98.7 percent at two microns. Longer Lasting
When used in conjunction with AMSOIL motor oil and an AMSOIL EaO or Donaldson Endurance filter, the EaBP should be changed every other full-flow filter change up to 60,000 miles. When used with other brands of motor oil or full-flow filters, the EaBP Filter should be changed every other full-flow filter change. AMSOIL recommends using oil analysis when extending oil drain intervals. Increased Oil Capacity
The increased fluid system capacity and filtration life provides improved oil cooling and ensures that equipment constantly runs on clean oil. Engine efficiency is increased, providing extended engine life. Soot Removal
AMSOIL has designed a high-efficiency by-pass filter element that is also a soot removal device. AMSOIL Ea By-Pass Filters use a synthetic/cellulose sandwiched media. The inner layer of the element is composed of a highly efficient cellulose media covered with a full synthetic media outer layer. These filters remove 39 percent of soot contaminants less than one micron. Soot removal efficiency increases approximately 10 to 14 percent when the EaBP Filter is used in conjunction with a standard full-flow filter. By-Pass Filtration Benefits Dramatically Extended Drain Intervals Improved Oil Cooling Increased Filtration Capacity and Life Increased Fluid System Capacity Efficient Small Particle and Soot Removal Significantly Extended Engine Life Equipment Constantly Runs on Clean Oil Increased Engine Efficiency Remove Particles Less Than One Micro
Dual Remote Filter System
The AMSOIL Dual Remote Oil Filtration System converts an engine full-flow oil filter system into a full-flow/by-pass oil filtration system by attaching an AMSOIL Full-Flow Oil Filter and AMSOIL Spin-On By-Pass Oil Filter onto a remote mount. The Dual Remote System provides superior filtration efficiency, increased oil capacity and improved oil filtration accessibility. | AMSOIL By-Pass Filter Replacement Chart | | Type of Unit | Stock Number | Size (Approx.) | Additional Oil Needed | Crankcase Capacity | Applications | | SINGLE SPIN-ON ELEMENT (Used with BMK21 or any DUAL REMOTE SYSTEM) | EaBP 90 | Diam. = 4.5 in.
Height = 6 in.
With Mnt. = 8 in. | 1 qt. | up to 9 qt. | Pleasure Vehicles, Light Trucks and Smaller Commercial Applications | | EaBP 100 | Diam. = 4.5 in.
Height = 8 in.
With Mnt. = 10 in. | 1.5 qt. | up to 15 qt. | | EaBP 110 | Diam. = 4.5 in.
Height = 10 in.
With Mnt. = 12 in. | 2 qt. | up to 21 qt. | | DUAL SPIN-ON ELEMENT (Used with BMK22 DUAL-GARD) | (2) EaBP 90 | Diam. = 5 in.
Height = 5.8 in.
With Mnt. = 8 in. | 2 qt. | 15 to 18 qt. | Large Trucks, Construction, Farm and Industrial Equipment (minimum sump capacity = 15 qt.) | | (2) EaBP 100 | Diam. = 5 in.
Height = 7.3 in.
With Mnt. = 10 in. | 3 qt. | 15 to 30 qt. | | (2) EaBP 110 | Diam. = 5 in.
Height = 10.4 in.
With Mnt. = 12 in. | 4 qt. | 15 to 42 qt. | | SPIN-ON ELEMENT (Used with BMK 30
Heavy-Duty By-Pass System) | (1) EaBP 120 | Width = 5.35 in.
Length = 12.12 in.
Height = 17.5 in. | 4 qt. | 15 to 42 qt. | Large Trucks, Construction, Farm and Industrial Equipment, (minimum sump capacity = 15 qt.), the BMK30 kit can be mounted in series for sump capacities greater than 42 quarts. | Normal Service Life:When used in conjunction with AMSOIL motor oil and an EaO or Donaldson Endurance filter, the EaBP should be changed every other full flow filter change up to 60,000 miles. When used with other brands of motor oil or full flow filters, the EaBP filter should be changed every other full flow filter change. AMSOIL recommends using oil analysis when extending oil drain intervals. |
a. Filters can be used on sumps of larger capacity but then require more frequent replacement. Full details on service life included with filter installation instructions NOTES: 1. Special adapters and hardware may be required for some installations. A universal mounting bracket is included with the kit, however, custom brackets may be required depending on your vehicle's equipment options or personal preferences in mounting locations." 2. Installing the Dual Remote By-pass system will result in a slight vibration sound on some applications. No harm to the engine will occur. Please contact AMSOIL Technical Service for more information. Contact AMSOIL INC. Technical Service for instructions before installing on vehicles with cast aluminum oil pans. Or call (715) 399-TECH (8324). By-Pass Spin-on Adapter Kits | Filter Thread | AMSOIL Part # | 3/4"-16 | BK295 | 13/16"-16 | BK296 | 18mm x 1.5mm | BK297 | 20mm x 1.5mm | BK298 | 22mm x 1.5mm | BK299 | 1"- 16 (Cummins) | BK300 | 1 1/2" 16 (PowerStroke 7.3L) | BK301 | 13/16" 16 (Duramax) | BK302 |
| | APPLICATIONS | Mount | Filter (Order separately unless noted) | BMK21 | Any size AMSOIL Spin-On By-Pass Filter Element | BMK23 | Any size AMSOIL Spin-On By-Pass Filter Element | BMK25 (Complete With Filters) | EaO26 and EaBP100 (complete with filters)
| BMK26 (Complete with Filters)
International Diesels | EaO26 and EaBP100 (complete with filters) and spin-on adapter | BMK27 (Complete with Filters)
Duramax Diesels (GM Pick-ups) | EaO26 and EaBP100 (complete with filters) and spin-on adapter | 
| Vehicles with sump capacities greater 15 qts. | Mount | Filter | BMK22 Dual Guard | Any size AMSOIL Spin-On By-Pass (mount requires 2 filters) |
|
Jim Hunt - AMSOIL Direct Jobber - 1-866-870-5048CLICK to Order Factory Direct from the Amsoil Online Store
CLICK For a Price Quote or Place an OrderAMSOIL is 100% "Made proudly in the U.S.A." |
|